Simple DIY Incubator [PICTORIAL]I've made this pictorial to share a method for creating a relatively cheap, effective, and spacious incubator. Please share your own methods, variations, or other input. This is my first pictorial so please bear with me if it goes through a number of iterations.
--------------------------
What you'll need:2 x medium/large thick, opaque plastic tubs with lids
(size should be based on your requirements, space, and resources). The tubs must be opaque to keep the mycelium in darkness.
1 x submergable aquarium heater
(optional: i'd recommend purchasing/trading for one with a thermostat – this will allow you to adjust the temperature of the water → mycelial environment).
1 x aquarium thermometer
(you can run the spectrum of hi to lo-tech solutions).
Optional:1 x timer – this is useful if your aquarium heater doesn't turn itself off periodically
(timer can be set to cycle the heater on and off).
Steps:1) Remove the lid from one tub and pour in water. I find that a level of ¼ to 1/5 is usually sufficient.
2) Attach the submergable aquarium heater to the bottom of the tub
(using a thermostat will require some experimentation to reach the desired incubator temperature).
3) Trail the heater cord up the side of the tub
(duct tape can be used to secure the wire though it's not strictly necessary).
4) Place the second tub into the water.
5) Attach the thermometer to the inside of the second tub.
6) Turn the heater on and monitor the incubator and temperature level for at least 5 hours, although I'd recommend watching it for 12-24 hours. This time period gives you a chance to dial-in the incubator for the optimal growth parameters of the species under cultivation using the thermometer and thermostat. Another reason I monitor the system is to ensure that there is no electric failure.
7) Load it up with jars or bags of your favourite legal edible or medicinal mushroom species.
(Note: Take into consideration the water-level of the first tub when adding more weight. It may be necessary to add upside-down jars to the bottom of the first tub to prevent damaging the heater from excessive load).
Continue to monitor thermometer periodically.
--------------------------
I hope you enjoyed this pictorial! Comments and opinions are encouraged.
Much love and light to you all.
Author
Topic: Simple DIY Incubator [PICTORIAL] (Read 10827 times)