Hardwood Cuttings: These are cuttings of dormant twigs or stems of woody plants. Such a cutting is usually taken in fall or winter. There should be two to four nodes or buds on the stem. This is inserted at an angle in sand, peat moss, or a combination of the two, with only the top bud projecting. It is then left in a cool place where it will not freeze, for the duration of winter. During this time the lower end will heal over or callus. In the spring, it is planted in a sandy soil where it will root readily, especially if the lower buds are removed.
Greenwood Cuttings: These are cuttings made of shoots of plants that are mature enough to break when bent sharply. These cuttings are rooted indoors in sand, gravel, or sandy peat moss almost up to the lower leaves. The lower leaves are often removed or cut to reduce the area exposed to air and so prevent wilting. The cuttings should have some leaves, though, as this will help them to root faster. They should be shaded and have gentle bottom heat. Many herbaceous plants maybe rooted in water. When rooting this way, never place the cuttings in more than 2 inches of water, as deep water does not absorb enough oxygen for good root development. If the cutting wilts, clip the leaves in half to reduce surface area, or placed a jar upside down over it. Rootone, a rooting hormone, may be used to hasten root growth. Plants from which cuttings are to be taken should receive plenty of sunlight for several days before the cutting is made. This builds up the sugar-energy storage and improves the success of the cutting.
Root Cuttings: These may be taken from any plant that produces sprouts from the roots. They are made from roots the thickness of a pencil to 0.5 inch thick, and 3 to 5 inches long. They need not show buds as buds will develop later. They are treated similarly to hardwood cuttings except that in the spring they are placed horizontally in the soil and entirely covered to a depth, of 1 to 2 inches.
Ground Layering: This is a method of rooting shoots while they are still attached to the parent plant. It is often used with plants whose cuttings refuse to root. Select a low-growing branch that can be bent to the ground. Make a slanting cut halfway through the branch at a point about 12 inches from the end, and just below a joint. Then wedge it open with a pebble. Bury the cut in about 4 inches of soil and anchor it with a stone. Stake up the end of the branch so that it extends above the soil line. Keep the soil moist, and carefully dig down to the cut every few months to check if rooting has taken place. Once rooted, the branch may be severed from the parent plant and grown like an ordinary cutting.
Air Layering: This is similar to ground layering but may be done with any branch. Select a branch from pencil size up to one inch thick. Make a slanting cut halfway through the branch. Wedge the cut open with a matchstick and dust the cut lightly with rooting hormone. With thick branches, a ring of bark should be removed instead of cutting the branch. Surround it with a handful of damp peat moss and enclose it with plastic wrap. Tie the wrap at both ends with wire tape. The peat moss should be kept damp. Check it frequently during the summer. In a month or two roots will form and the branch may be severed and treated like an ordinary cutting.
Division: This is the process of dividing plants that have root stocks or tubers, or which produce suckers (young plants rising from the base of the older plants). This may be achieved by breaking up large clumps of plants such as heliotrope, or cutting tubers or rootstocks into sections containing buds, as is done with potatoes or hops. Division is usually performed during the dormant season.
Separation: This is a form of division. It is the process of separating bulblets from the main bulb in the same way garlic is propagated, and setting them out to be new plants.
Please remember:" Plants should be grown with joy in one's heart and with calmness in one's actions. If you dislike your plants or the responsibility they represent they will often refuse to grow."
Author
Topic: Vegetative Propagation- Cuttings Info (Read 2072 times)